How unpleasant it is to take a shower and suddenly notice that the water is going up to your ankles because it is not flowing or not? Unclog your drain yourself with these simple tips. Unclogging a drain shouldn’t be a very difficult or messy thing to do. There are a number of effective ways to re-circulate water when dealing with a clogged drain. Here are a few that are very easy to perform. The Blocked Drain Essex service happens to be the best deal there.
Use a plunger
It is a fairly simple solution and one of the most popular drain unblocking equipment. Sometimes it only takes one or two tries and your problem can be fixed in seconds:
- First, make sure there is water in the tub or sink. If there is not already, add 2 to 3 cm,
- Next, block any adjoining drain or vent to ensure that there is only one air inlet in the blocked drain,
- Then cover the drain completely with the diver’s head, which should form a suction cup from which no air can escape,
- Using both hands, push and pull the diver’s head up and down. It does not matter which way the air passes, as long as movement is created in the drain to dislodge the blockage,
- After a few back-and-forth movements, remove the plunger to see if the water is draining. Then repeat these gestures if necessary. It might take three or four attempts to dislodge some blockages,
If it is a bathtub, it is recommended to remove the cover from the overflow plate and block the air passage with a cloth. However, do not push it too far.
Combine baking soda and vinegar
Baking soda and vinegar, when mixed together, can create an impressive chemical reaction that can also be mildly corrosive. This recipe can sometimes eat away at what is clogging your drain. Just mix the two ingredients. As soon as everything starts to sparkle, pour the mixture down the clogged drain and get some boiling water to rinse off the corroded debris.
Or, baking soda and salt
Another potential chemical reaction that you may be able to create from ingredients that are in your kitchen can be achieved with a mixture of salt and baking soda. Mix 125 ml (1/2 cup) of baking soda with 125 ml (1/2 cup) of salt and pour everything down the drain. About 20 minutes later, add boiling water to it. Pour the water down the drain and watch the chemical reaction take place.
Getting rid of a clogged drain sometimes takes creativity, but sometimes it’s not enough. In this case, call on the real specialist: the plumber. Act quickly when water begins to flow slowly down a drain. It’s so much easier and cheaper than hiring a plumber for a big plug. The solution is simple, and it only requires common household items.
If you notice that water is slowly draining down a drain
This means that “sludge” collects in the pipe. When this happens, pour 250 ml (1 cup) of salt down the drain, followed by 250 ml (1 cup) of baking soda. Then, pour a full kettle of boiling water down the drain. The abrasive mixture of salt and baking soda will destroy the clog. If the problem is with frozen grease, the plug will immediately fall apart. Do not turn on the faucet for several hours, if possible. The longer you avoid diluting your work, the better.